Raritan PCS12 User's Guide download pdf (Page 33)

Chapter 3: Prepare Raritan Devices

Diagram Key

Serial Console Ports. Most Cisco RJ45 or Sun RJ45 Serial Ports require Rollover Cable (p/n

CRLVR-15)

KVM Console Ports, KVM Console Cable (p/n CCPTxxx)

* Connection to Local or Admin Port, depending on unit type.

The local port and the Admin Port locations depend on the Dominion KSX model you

purchased. Dominion KSX units have a label on the underside of the chassis identifying the

hardware version. The models that read either: Chassis RX440-F/S-0B or -0D or Chassis

RX880-F/S-0B or -0D have the Local Admin ports on the rear panel and Local Access

Console ports on the front panel (behind the bezel). For those models with labels that read

Chassis RX440-F/S-0F or Chassis RX880-F/S-0F; these locations are reversed: the Local

Admin ports are found on the front panel (behind the bezel) and Local Access Console ports

are on the rear panel. Please consult the labeling on your Dominion KSX unit to determine

where the Local and Admin ports are located.

Attach Power Cord and Local Console

1. Connect the included AC power cord to the Dominion KSX unit and

plug into an AC Power Outlet.

2. Attach a PS/2 keyboard and multi-sync monitor to the corresponding

local Admin Console ports on the Dominion KSX. Depending on your

KSX model, the local Admin Console ports may be on the front

(remove the front bezel by pulling it towards you) or the rear panel of

your KSX unit. The local Admin Console is used during initial setup,

but may be removed after setup is complete.

3. Power ON the Dominion KSX.

Set Dominion KSX IP Address

1. After booting, the Dominion KSX displays the Setup Wizard on the

Admin Console screen. Press B on the Admin Console keyboard to

begin the initial configuration.

2. On the Network Configuration Screen, assign a unique name (for

example, “Atlanta Office”) and IP Address parameters for this

Dominion KSX unit. Please refer to Raritan's Dominion KSX User

Guide for additional information on administrative parameters.

3. Press CTRL+S to save the settings. The Main Menu appears.

4. Press R to restart.

5. Press ENTER.

6. Press R again to reboot the Dominion KSX.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 69 70

No comments

Raritan PCS12 User's Guide Page 33