Raritan PCS12 User's Guide download pdf (Page 30)

Chapter 3: Prepare Raritan Devices

Dominion SX Devices

The following section provides you with the necessary background

information and steps to install and configure Raritan Dominion SX units

to conform to CC-SG's requirements.

Note: Be sure to document the device name, IP address, administrative

username and password, and attached systems (port number, type,

system name) in Installation Template (on page 53).

Attach Power Cord and Installation Computer

1. Obtain a computer with a network card and a crossover network

cable. This computer will be referred to as the installation computer.

2. Connect the crossover network cable to the primary LAN connection

on the rear panel of the unit. On models with two Ethernet interfaces,

the primary LAN is LAN 1.

3. Connect the other end of the crossover network cable to the network

port on the installation computer.

4. Connect the included AC power cord to the Dominion SX unit and

plug into an AC Power Outlet.

5. Power ON the Dominion SX unit.

Note: The SX unit performs a hardware self-test, indicated by the

green light on the back of the unit, and then starts the software boot

sequence. The boot sequence is complete when the green light goes

on and remains illuminated.

Set Dominion SX IP Address

1. Access the SX unit through your installation computer's browser on

the same subnet by typing the default URL https://192.168.0.192 into

the address field.

2. Log in with the default username (admin) and password (raritan).

3. Follow the prompts to change the default password. Be sure to make

a note of the new password.

4. Click the Setup tab to display the Configuration and Logging topics.

5. Click the Network section of the Setup Configuration screen.

6. Type the data in the following fields: IP Address: Network address for

this unit; Subnet Mask: Subnet mask for the network where this unit

will reside; Gateway IP Gateway: Default gateway for this unit.

7. Accept all other default values or change as needed.

8. Click OK to save the settings. The SX unit reboots automatically

once it has been configured.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 69 70

No comments

Raritan PCS12 User's Guide Page 30