Raritan LARA ECO User Manual download pdf (Page 25)

CHAPTER 4. CONFIGURATION 15

Chapter 4. Configuration

Initial Configuration

The LARA eco’s communication interfaces are all based on TCP/IP. It comes

preconfigured with the IP configuration listed in Table 4 - 1.

Table 4 - 1. Initial Network Configuration

Parameter Value

IP auto configuration DHCP

IP address -

Netmask 255.255.255.0

Gateway none

IP access control none

LAN interface speed none

LAN interface duplex mode none

Warning: If the DHCP connection fails on boot up, the LARA eco will not

have an IP address.

If this initial configuration does not meet your requirements, the following describes the

initial IP configuration that is necessary to access the LARA eco for the first time.

LARA eco Setup Tool

The setup tool is used to determine the IP address assigned to the LARA eco by the DHCP

server or to change the device’s initial network configuration.

Connect the LARA eco to your computer either via local network or via USB. Start the

setup tool from the CD ROM on the computer where the LARA eco is installed. Depending

on the connection (USB or network), the device detection is different.

Note: Configuration via network requires the device to have a valid IP address. If your

network provides a properly configured DHCP server the LARA eco should be

automatically assigned an IP address.

A window opens as seen in Figure 4 - 1 (on aWindows OS) and Figure 4 - 2 (on a Linux

OS).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 102 103

No comments

Raritan LARA ECO User Manual Page 25