Raritan LARA ECO User Manual download pdf (Page 24)

14 PRODUCT USER GUIDE

Connecting the External Reset/Power Option

Please refer to the manual of the Peppercon external power switch option to connect this

external device to the serial interface on the rear side of the LARA eco. By the date of

printing this manual supported options are:

• Inline Power Module IPM 220-L

Connecting the Ethernet

The rear side of the LARA eco provides a RJ45 connector for Ethernet. The connector is

used either for a 100 Mbps 100Base-TX connection or for a 10 Mbps 10BASE-T

connection. The adapter can sense the connection speed and will adjust to the appropriate

operation mode automatically.

10 Mbps Connection

For 10BASE-T Ethernet networks the Fast Ethernet adapter uses category 3, 4, or 5 UTP

cable. To establish a 10 Mbps connection, the cable has to be connected to a 10BASE-T

hub.

1. Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.

2. Align the RJ45 plug with the notch on the adapter’s connector and insert it into

the adapter’s connector.

100 Mbps Connection

For 100BASE-TX Ethernet networks the LARA eco supports category 5 UTP cabling. To

establish a 100 Mbps connection, the cable has to be connected to a 100BASE-TX hub.

1. Make sure that the cable is wired appropriately for a standard 100BASE-TX

adapter.

2. Align the RJ45 plug with the notch on the adapter’s connector and insert it into

the adapter’s connector.

Warning: The UTP wire pairs and configuration for 100BASE-TX cable are

identical to those for 10BASE-T cable when used with category 5 UTP

cable.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 102 103

No comments

Raritan LARA ECO User Manual Page 24